By Steeltown on
May. 25, 2012
Clearwater,
FL,
United States
I have two cap platens that should fit many manual presses. I cleaned the tack of the print surface, and they are perfect except for a little pitting on one of them that would make no difference in their use on caps. The two angled metal pieces are the back support for the bill of the cap to hold it upright. Those mount on the threaded rods on the cap platen. The nuts for that are not included. I did not clean any other part of them except the platen surface and the support plates.
Make me an offer.
Pics attached.
