I'm actually posting this for one of my very good clients who has taken her business in a different direction and would like to eliminate some excess equipment.
This is pretty much a turn key stone etching setup consisting of the following:
9 15" Gerber tractor feed rubber plotter/cutters
Omega software to run the cutters (i believe a pc as well)
Rubber and transfer material rolls
Sandblasting booth with built in auto X/Y carrage feed system for the blaster nozzle, I'd say about 10ft x 4ft x 8ft high with I beam and trollys for moving material in and out.
60HP rotary compressor with refrigerated dryer and 2 220(maybe 250) gal storage tanks
Sand hopper and pressure tanks and large dust collector to match.
Also a few misc carts for material handeling.
The company was cutting rubber stencils and sandblasting patterns into stone. The booth looked like it could handle X/Y feed over appoximately a 4'x8' surface area.
She would prefer to sell as a whole setup but is open to negotiation. All equipment is still in place and functional.
The shop is located near Windsor Ontario Canada. If you are seriously interested in something like this I can put you in contact with the owner just PM me.
Thanks
Tom.