I have 12 Brand new in box - never used. STF 18x20 ID ST roller frames that I bought a couple years ago. Nice tension frame with square rear tube. These were $30 each. ($360 value)
http://www.texsourceonline.com/p-1134-stf-roller-frames.aspx
I have matching pre-cut mesh inserts for the frames. These are shur-loc 18x20 inserts. I have 12 x 380/34 panels new in packaging, 6 x 230/48 and 6 x 305/34. The current pricing from shur-loc (retail) is:
380: $35 each, ($420 total value)
305: $24 each, ($144 total value)
280: $21 each. ($126 total value)
I believe they use all sefar mesh in these panels.
I have a generic brand new (again never used) CYGM tension meter. Chinese made but I tested it again known meter and its perfectly accurate. (Cost $275)
FYI Shur-loc also allowed me to swap higher mesh count panels for lower count panel - if you don't want the more expensive panels.
I was planning on doing some specialty printing and never did so I I will sell everything for one low price of $600 (over $1200 value). :)
-glenn