M&R Sidewinder 6/6 & Misc

By sben763 on Mar. 12, 2018
West Lafayette, IN, United States

M&R Sidewinder 6/6 Rear clamp. 15x16 platens. all rubber good shape. rebuilt micros with new guide plates 3 years ago. 2006 and I have owned since 2009-2010. Needs spring replaced(I have 2)just needs put on.

$3500 for press and 15x16 platens

4 sleeve/pant leg platens 5"x22" $160
4 infant 9"x10.75" $120
3 18x28 honeycomb style $225
6 Action engineering 18x20 platen new condition only used a couple of times with platen tape $600
Newman Pin Registration Old style with workhorse wood platen rectangular tube style. full size pin board and exposure unit jig. 12 carrier sheets $500

Newman Pin Registration new style on M&R 15x16 or 16x16 platen full size pin board film to frame bar and at least 50 carrier sheets $1500

I hate to sell press but upgraded to auto and don't have the room right now. I put fair prices so please no low ball offers. I am not hard up for the $$$ nor I am getting out of the business

Screen Printing

There are 11 Comments

Submitted by sben763 on Fri, 03/16/2018 - 23:21

I should add this is the short arm version of the Sidewinder 8.5-9ft

Pm me or email my username @gmail.com

Submitted by sben763 on Sun, 04/29/2018 - 11:44

Have had a lot of interest and a lot of questions.

If this post isn’t marked sold then it’s still available.

Yes I will ship pending full payment clearing and buyer pays shipping. I can create for free with scrap lumber from my construction company. 47906 is location. Press is about 1000lbs so 1200 with create. If I build create pickup with tailgate by shipping company is required.

Before putting is storage I put grease on all machined surfaces and bearing surfaces.

I also made a calibration jig for the press I may be willing to include. I was going to alter for my auto but think I’m going to just make a new one

Submitted by Jay.boriken on Fri, 06/08/2018 - 14:05

sben763 wrote:
Have had a lot of interest and a lot of questions.

If this post isn’t marked sold then it’s still available.

Yes I will ship pending full payment clearing and buyer pays shipping. I can create for free with scrap lumber from my construction company. 47906 is location. Press is about 1000lbs so 1200 with create. If I build create pickup with tailgate by shipping company is required.

Before putting is storage I put grease on all machined surfaces and bearing surfaces.

I also made a calibration jig for the press I may be willing to include. I was going to alter for my auto but think I’m going to just make a new one

Do you sell individual

2025 © DigitSmith | Terms and Conditions | Privacy Policy | Contact