HELP! Need TAJIMA X-Y card

By faisaltef on Jan. 31, 2012
Forums: 
Embroidery and Digitizing

I Need TAJIMA MACHINE X-Y CARD. SOMEONE PLEASE HELP ME FOR WHERE I COULD BUY THIS.

Location: 
United States
Submitted by designbyczar on Fri, 01/18/2013 - 12:07

faisaltef wrote:
i want a perfect address where from i buy it. i want its price.
please help.

Hi, this is Czar. I have a DU10 Card if you have interest on it may you contact me at (210) 538 9309 or email me at czar@designbyczar.com Thanks

Sulp's picture
Submitted by Sulp on Wed, 02/01/2012 - 13:00

Call Hirsch. (800) 394-4426. But those cards are not cheap. Expect a few thosand dollars for a replacement XY card. Did you burn something up that you can see or smell? The reason I ask is because I just had a Tajima S-card burn up on me and they wanted $1000 for a new card and $650 to fix it. I have no electrical experience whatsoever but I could see what part burnt up on the board. I removed it and did about an hours worth of re-search and found out what it was. It turned out to be a Thyristor (which I had never heard of). I called around and eventually found an electronics company that had something very similar. He sent me 6 of them for $15 and I bought a $20 soldering iron. I soldered the new part on the board in about 10 minutes and the machine is running beautifully now...Total cost: $35 and about 2 hours in time.

Submitted by dgeorge on Wed, 02/01/2012 - 16:40

all the time the problem is :
the part(s) cost is 1$ and 999$ because the tech. know what part(s) to change.
you can try also plrelectronics.com if you want to fix the card.
but again.what model is your driver?

Submitted by ldiaz on Fri, 02/10/2012 - 23:37

I had the same problem, but I was fortunate enough to have some connections in Mexico and ended up repairing the card instead of buying a new one.

Submitted by dgeorge on Sun, 02/12/2012 - 17:08

time to time i fixed DU10 changed V MOS power module MP 6101
but not all the time must be the same.
you need some experience and tools to change this circuit.
pay attention is four layers board !

Submitted by dgeorge on Mon, 02/13/2012 - 09:33

pay attention

some DU10 drivers are special made for TME-H OR TMEG models
you must tell exactly your machine model

Submitted by dgeorge on Tue, 02/14/2012 - 07:25

in 18 years i never changed both X&Y drivers at the same time(only X or Y)
if LED s drivers are off maybe one phase is missing ( check the fuses)
anyway if you will change the drivers ,you must check frame drive system(belts,pulley,shafts,bearings etc.)
if mechanical is something wrong you will burn the driver again.

2024 © DigitSmith | Terms and Conditions | Privacy Policy | Contact