Roland SP-300V 30" VersaCamm Large Format Printer & Cutter w/ Desktop

972-745-2222
$4500
Both Print Head works Great and was replaced less than 4 month ago.
Used Roland Ink only so no clogs.
Will also include all 4 color ink about half used so you can start printing as soon as you buy it
Upgraded the shop with SolJet 54 so don't need the 30 inch no longer.
Recently serviced so has New captops, new dampers, new encoder strip, new sponge, new wipers, new sheet cut knife, new cutter blade. It is Production Ready
Great buy for someone getting into this market
Look on ebay or other sources - not going to find this under $7000 with all the print head working.

Can send a test print but recommend you to come by and watch it print before you buy.
You are buying a used Roland SP-300V 30" VersaCamm Large Format Printer & Cutter with desktop. The product has been inspected and tested. The product is in great condition and works great. If you have any questions, please ask.

This unit will come with Desktop Tower with VersaWorks software to run the Roland Printer. Including Corel Draw Pre-installed. Value. No disks are included.

Keyboard and Mouse included.

This product is set for local pickup. If you would like to have the unit shipped to you, please send us an email for details.
Printing/Cutting method Piezo ink-jet method/media-moving method

Acceptable media width

182 to 762 mm (7-3/16 to 30 in.)

Printing/Cutting width*1 Maximum 736mm (29 in.)

Ink cartridges Capacity 220 cc ± 5 cc Four colors (cyan, magenta, yellow and black)

Printing resolution (Printing dot resolution) Max. 1440 dpi

Acceptable tool Special blade for CAMM-1 series

Cutting Speed 10 to 300 mm/s

Blade force 30 to 300 gf

Blade offset compensation 0.000 to 1.500 mm (0 to 0.0591 in.)

Software resolution (When cutting) 0.025 mm/step (0.000984 in./step)

Distance accuracy (When Printing)*2*3 Error of less than ±0.3 % of distance traveled, or ±0.3 mm, whichever is greater

Distance accuracy (When cutting)*3 Error of less than ±0.4 % of distance traveled, or ±0.3 mm, whichever is greater
When distance correction has been performed (when the setting for [CALIBRATION] - [CUTTING ADJ.] has been made): Error of less than ±0.2 % of distance traveled, or ±0.1 mm, whichever is greater

Repetition accuracy (When cutting)*3*4 ±0.1 mm or less

Repetition between printing and cutting*3*5 ±0.5 mm or less

Alignment accuracy for printing and cutting when reloading media *3*6 Error of less than ±0.5 % of distance traveled, or±3 mm, whichever is greater

Media dryer Heating method, Setting range for the preset temperature: 35 to 50°C (95 to 122°F)