Too much excess equipment - this has to go

We have way too much excess equipment sitting around taking up space. Some very good and some not so good but it all needs to go. All pieces are located in Terre Haute Indiana and transportation is the buyers responsibility. For photos email tshirt1@gmail.com

M&R Maxi-Cure 1998 in new condition. This unit was purchased new by Indiana State University in the summer of 1998. The university was trying to get a printing program off the ground. The printing program fizzled out and this machine sat in the basement of the technology building for over 10 years. If it has been used at all then the hours are very, very low. I was going to use it as a back up for my gas dryer and have changed my mind. Comes with the original owner’s manual. I am asking $4,500, as is, and moving it is 100% the buyers’ responsibility. Compare it to others at $5,000 and up. The unit is located in Terre Haute Indiana.

Specs:
Model M&R MC 36-6-1
S/N 079833374M Machine # 0320
Belt 36”
2’ Infeed - 6’ Heat - 2’ Outfeed
3 - 12” x 36” IR panels with expansion room for a fourth.
208/240v 57/64 amps

Raynar 4 / 1 Manual Press
This old Raynar is well worn but still good for one color dark ink on lights or multi color where registration is not an issue. This machine has been converted to a square tube platen arm. If we had room we’d have it on the floor just for the capacity. It was in daily production until December 2006. We get several orders a week where we just need one head and this would fill the bill. Includes the 12” x 12” flash unit that came with it. Only $250 and you arrange transportation. Machine located in Terre Haute Indiana.

Tajima TMEX-C1201. 1997, one head - twelve needles. Hoops. Factory maintained. This machine has been in daily use and is being rotated out because we upgraded to a larger machine. A great starter machine to add embroidery. Asking $4,000 and transportation is buyer’s responsibility. Available first week of September. Email

Harco 4/1 Manual Press
This saw very limited use in our shop due to room constraints. It has been converted to a square tube arm for platens. $100

Lawson Lil Imp
Single color. Comes with vacuum table, pump, squeegee and floodbar. Also has shirt board. Asking $750

email tshirt1@gmail.com